diff options
Diffstat (limited to 'docs')
| -rw-r--r-- | docs/feature_haptic_feedback.md | 19 |
1 files changed, 10 insertions, 9 deletions
diff --git a/docs/feature_haptic_feedback.md b/docs/feature_haptic_feedback.md index b456bad736..02a231138d 100644 --- a/docs/feature_haptic_feedback.md +++ b/docs/feature_haptic_feedback.md @@ -4,11 +4,12 @@ The following options are currently available for haptic feedback in `rules.mk`: -``` +```make HAPTIC_ENABLE = yes -HAPTIC_DRIVER += DRV2605L -HAPTIC_DRIVER += SOLENOID +HAPTIC_DRIVER = drv2605l +# or +HAPTIC_DRIVER = solenoid ``` The following `config.h` settings are available for all types of haptic feedback: @@ -92,7 +93,7 @@ This driver supports 2 different feedback motors. Set the following in your `con Eccentric Rotating Mass vibration motors (ERM) is motor with a off-set weight attached so when drive signal is attached, the off-set weight spins and causes a sinusoidal wave that translate into vibrations. -``` +```c #define FB_ERM_LRA 0 #define FB_BRAKEFACTOR 3 /* For 1x:0, 2x:1, 3x:2, 4x:3, 6x:4, 8x:5, 16x:6, Disable Braking:7 */ #define FB_LOOPGAIN 1 /* For Low:0, Medium:1, High:2, Very High:3 */ @@ -105,7 +106,7 @@ Eccentric Rotating Mass vibration motors (ERM) is motor with a off-set weight at Linear resonant actuators (LRA, also know as a linear vibrator) works different from a ERM. A LRA has a weight and magnet suspended by springs and a voice coil. When the drive signal is applied, the weight would be vibrate on a single axis (side to side or up and down). Since the weight is attached to a spring, there is a resonance effect at a specific frequency. This frequency is where the LRA will operate the most efficiently. Refer to the motor's datasheet for the recommanded range for this frequency. -``` +```c #define FB_ERM_LRA 1 #define FB_BRAKEFACTOR 3 /* For 1x:0, 2x:1, 3x:2, 4x:3, 6x:4, 8x:5, 16x:6, Disable Braking:7 */ #define FB_LOOPGAIN 1 /* For Low:0, Medium:1, High:2, Very High:3 */ @@ -170,13 +171,13 @@ List of waveform sequences from the datasheet: | 42 | lg_dblclick_med_80 | 84 | transition_rampup_med_smooth1 | | | ### Optional DRV2605L defines -``` -#define DRV_GREETING *sequence name or number* +```c +#define DRV2605L_GREETING *sequence name or number* ``` If haptic feedback is enabled, the keyboard will vibrate to a specific sequence during startup. That can be selected using the following define: -``` -#define DRV_MODE_DEFAULT *sequence name or number* +```c +#define DRV2605L_DEFAULT_MODE *sequence name or number* ``` This will set what sequence `HF_RST` will set as the active mode. If not defined, mode will be set to 1 when `HF_RST` is pressed. |